The EnigMat PCM Blanket, priced and ready to install
Flexible phase-change blankets that absorb peak heat and release it overnight. Installs over existing decking, joists, and rack tops with standard fasteners.
For facility managers, that means fewer compressor starts, shorter cooling cycles, and a 2–6 hour thermal lag that shifts load away from peak-rate hours. It works alongside existing batt, blown, or spray-foam insulation — complementing R-value rather than replacing it.
- Price
- $3.80 / ft
- Unit
- 1 linear foot = one 12" × 48" blanket
- Best for
- Roofs, attics, warehouse envelopes, racks, and cold chain
Four placements that pay
Walls
Behind drywall or over sheathing, the blanket buffers solar gain through the wall assembly and steadies interior surface temperatures.
Ceilings & plenums
Above ceiling joists or on the ceiling plane, it slows the downward heat push from hot roof cavities so upper floors stop overheating.
Attics & ductwork
Rolled over attic insulation and around duct runs, it cuts attic peak temperatures and protects the ducts that waste the most cooling.
Roofs & warehouse envelopes
Laid over decking or purlins on large-span buildings, it flattens afternoon peaks across the whole conditioned volume.
$3.80 per linear foot, less at volume
One linear foot equals one 12″ × 48″ blanket. Volume discounts apply automatically to every quote. Freight is quoted separately by destination and pallet count.
Standard rate. Ships palletized in 2–5 business days.
10% volume discount applied automatically to your quote.
15% volume discount plus freight consolidation on request.
Linear feet of coverage along the thermal envelope.
Four steps, no downtime
A typical 1,200 ft retrofit is completed by a two-person crew in a single shift, with no specialty trades and no operational shutdown.
Measure & plan
Confirm linear footage along the thermal envelope — wall runs, ceiling planes, attic joist bays, or roof decking. Add a small overage for trim allowance and joint overlap.
Prep the surface
Sweep the substrate clean. No primer or adhesive is required — blankets sit directly over decking, joists, sheathing, or rack tops.
Lay & fasten
Run blankets in the long direction, overlap seams 2″, and secure with #8 self-tapping screws or 11″ cable ties every 24″.
Verify coverage
Walk the run for gaps at penetrations, ducts, and edges. Continuous coverage is what delivers the 2–6 hour thermal lag.
Tape measure · utility knife · cordless driver · #8 screws or 11″ cable ties
2 installers · ~150 ft / hour · no specialty trades or shutdown
Reach our team directly
Send your footage and project details and we'll reply with a sealed quote, lead time, and freight estimate. Prefer to talk it through? Call (239) 318-8298 or email thermafaze@gmail.com.